# Rules for Arithmetic Operations with Significant Figures

The result of a calculation involving approximate measured values of quantities (i.e. values with limited number of significant figures) must reflect the uncertainties in the original measured values. It cannot be more accurate than the original measured values themselves on which the result is based.In general, the final result should not have more significant figures than the original data from which it was obtained. Thus, if mass of an object is measured to be, say, 4.237 g (four significant figures) and its volume is measured to be 2.51 cm

^{3}, then its density, by mere arithmetic division, is 1.68804780876 g/cm

^{3}up to 11 decimal places.

It would be clearly absurd and irrelevant to record the calculated value of density to such a precision when the measurements on which the value is based, have much less precision. The following rules for arithmetic operations with significant figures ensure that the final result of a calculation is shown with the precision that is consistent with the precision of the input measured values :

**In multiplication or division, the final result should retain as many significant figures as are there in the original number with the least significant figures.**

Density = = 1.69 g cm

^{3}

Similarly, if the speed of light is given as 3.00 Ã— 10

^{8}m s

^{-1}(three significant figures) and one year (1y = 365.25 d) has 3.1557 Ã— 10

^{7}s (five significant figures), the light year is 9.47 Ã— 10

^{15}m (three significant figures).

**In addition or subtraction, the final result should retain as many decimal places as are there in the number with the least decimal places.**

Similarly, the difference in length can be expressed as:

0.307 m â€“ 0.304 m = 0.003 m = 3 Ã— 10

^{â€“3}m.

Note that we should not use the rule (1) applicable for multiplication and division and write 664 g as the result in the example of

**addition**and 3.00 Ã— 10

^{â€“3}m in the example of

**subtraction**. They do not convey the precision of measurement properly. For addition and subtraction, the rule is in terms of decimal places.